垚航中空塑料模板质量检验方法
5.耐高/低温测试
垚航塑料中空模板可在-10℃-45℃的温度下正常使用。
①将塑料模板样品放入-10℃的冰箱中24小时,然后在离模板边缘10mm处钉钉,检查是否有裂缝。 如果有裂纹,该模板在冬天不可用;
②将塑料模板样品放入45℃的热水中5min后检查是否软化。 如果软化,该模板在夏天不可用。
Quality Inspection Method of Yaohang Hollow Plastic Formwork
① Put the plastic formwork sample into fridge of -10℃ for 24 hours, then nail at 10mm away from the edge of the mold to check if there is cracks. If so, the formwork is unavailable in winter;
② Put the plastic formwork sample into 45 ℃ hot water for 5min to check if it would be softened. If so, the formwork is not available in summer.

- 柔韧度测试
- 承重力检测
- 收缩力检测
- 吃钉状态
5.耐高/低温测试
垚航塑料中空模板可在-10℃-45℃的温度下正常使用。
①将塑料模板样品放入-10℃的冰箱中24小时,然后在离模板边缘10mm处钉钉,检查是否有裂缝。 如果有裂纹,该模板在冬天不可用;
②将塑料模板样品放入45℃的热水中5min后检查是否软化。 如果软化,该模板在夏天不可用。
Quality Inspection Method of Yaohang Hollow Plastic Formwork
- Flexibility test
- Weight capacity detection
- Shrinkage test
- Nail-holding strength
- High/low temperature test
① Put the plastic formwork sample into fridge of -10℃ for 24 hours, then nail at 10mm away from the edge of the mold to check if there is cracks. If so, the formwork is unavailable in winter;
② Put the plastic formwork sample into 45 ℃ hot water for 5min to check if it would be softened. If so, the formwork is not available in summer.